G5 Prybabies

Howdy Folks,

It's a cold and slightly dreary afternoon here today, good time for a sale. :)

Today I have the first wave of G5 Prybabies done. These are stonewashed S35v and they are similar to the earlier G3 design with a couple of small improvements. For this design I have changed the old grippy thumb scallops along the edge to hex indents which works well with the overall design and provides a unifying effect. I also added about 1/8" of length to the tool by bolstering the thickness on the butt end. This adds strength to the wrench set. Speaking of the wrench set, it remains SAE with sizes ranging from 1/4"-9/16". The bottle opener cut out area wrench is a SAE 7/16". OAL is just over 3 1/8".

2/14/11: I just noticed that I mistakenly put on the insert cards that these are S30v steel, They are in fact S35v steel. Sorry for the mixup.

This is the first wave, a few more remain to finish up tomorrow or Monday. No stamped ones in this batch and there won't be any XLs here either as I would have to revert back to the Original old school pattern for any XLs to happen.

The G5 Prybabies run $60 plus shipping and the link is below:

First wave is sold out, thank you so much! :)